Black & Decker DCM200C Guía de instalación descargar pdf (Pagina 9)

DCM 200 Installation

Page 9

DCM 200 Controller Enclosure Mounting (continued)

• Individual DCM 200 controllers are shipped with mounting bracket (4) and mounting screws (1) to

assist with wall mount installation.

• Snap the bracket off the back of the enclosure by pressing the release clip (4) at the bottom, and slide

the enclosure off the bracket. The wall mounting bracket can then be used as a drilling template.

• Mount the bracket on a vertical wall at approximately eye level, within 3ft. of the nearest 120VAC

power outlet. Alternatively, mount near a power disconnect, and wire the power directly to the

controller through electrical conduit. Refer to local and national electrical codes for wet locations.

• Fasten enclosure securely to the bracket as shown, by hanging enclosure on the bracket, pushing the

enclosure against wall and lifting until the enclosure snaps securely to the bracket.

• After controller is mounted, time is best used mounting the DGMa modular sensor housing to allow

sensors to equilibrate while the remainder of the installation, wiring and configuration is performed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Sin comentarios

Black & Decker DCM200C Guía de instalación Pagina 9