Black & Decker DCM200C Guía de instalación descargar pdf (Pagina 8)

DCM 200 Installation

Page 8

2.2 Mounting

1.1.

1.2. Fully Assembled System on Acrylic Backpanel

1.3.

1.4. Overall System Mounting

• Locate an area on a flat wall large enough to

accommodate the full size of the 22x22” system

panel with enough extra room to accommodate

flexible sample tubing. The controller is shipped

with a 3 ft. power cord already installed, for easy

connection to a close wall receptacle.

Alternatively, you may choose, or be required, to

install conduit into the bottom of the controller

enclosure. Refer to Section 4.4 for enclosure

opening sizes and locations.

• Refer to dimensional drawings in appendix section

for location and spacing of pre-drilled mounting

holes, measure and mark these locations on the

wall.

• Approximate weight of the assembled system with

water flowing may be in excess of 30 lbs., so take

care to choose adequately sized mounting hardware.

1.5. Individual Components

DCM 200 Controller Enclosure Mounting

•

Locate an area on a vertical wall where the

controller can me mounted at approximately eye

level and have enough clearance to allow the

DGMa modular sensor housing to be installed near

and below the controller. The location of the

sensor housing must have about 18” of clearance

above it to allow removal of the sensors, and about

12 inches below to access water sample petcock

and a sample cup.

NOTE: a common mistake made at installation, is

not allowing enough space above the sensor

housing to accommodate easy sensor maintenance.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 33 34

Sin comentarios

Black & Decker DCM200C Guía de instalación Pagina 8