Black & Decker DCM200C Guía de instalación descargar pdf (Pagina 16)

DCM 200 Installation

Page 16

CAUTION

BASIC SAFETY PRACTICES AND MOST LOCAL ELECTRICAL CODES

REQUIRE THIS CONTROLLER’S ELECTRICAL POWER TO BE

PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER (GFCI).

2.3.1. 120VAC Line Power and Feeder Wiring

The factory pre-wired your controller with a power cord and two 120VAC receptacle cords, unless you

requested otherwise. For conduit wiring configurations, remove the cords supplied and replace the

cord wiring with the individual wires from the conduit. The same terminals are used and are shown in

the diagram below for reference.

NEVER CONNECT FEEDER DIRECTLY TO POWER SOURCE

If the chemical feeders are connected to a wall outlet, the safety

devices integral to your ProMinent controller, and to the safe

feeding of chemicals, will be bypassed. It is very important that

the chemical feeders be connected to the controller and never

directly to a wall outlet. If the chemical feeders are connected to a

wall outlet and feeding continuously, when the flow of water to the

pool stops due to filter backwash, the circulation pump losing

prime or other causes, potentially hazardous concentrations of

chemicals can be fed into a pool or spa. Follow Instructions

carefully to insure safe operation.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Sin comentarios

Black & Decker DCM200C Guía de instalación Pagina 16