Black & Decker DCM200C Guía de instalación descargar pdf (Pagina 22)

DCM 200 Installation

Page 22

4.3. Browser Passwords & Lockout

After 5 unsuccessful attempts to log on, the controller locks out Ethernet and Keypad access

Locked out users will see an Alarmed status message in place of Password Incorrect .

Browser & modem resets at 7:00AM or when AC power OFF/ON.

Therefore, the maximum lockout time is 24 hours and the minimum is less than a minute.

This feature blocks scripting attacks on controllers and cannot be disabled.

There is no limit on the number of keypad password attempts.

Changing all passwords from their default values is strongly recommended for Ethernet connected controllers.

Passwords can be reset to the factory default by logging on as the Reset Pswrds user.

Refer to Browser Manual for more information.

4.4. LCD Keypad Passwords

Passwords are defaulted OFF for keypad users.

The System/Password menu item does not display unless System/Configure has turned passwords ON.

Once passwords are turned ON, only the administrator can access System/Configure to turn Passwords OFF

If passwords are ON, you are prompted with the required password level; Admin / Configure / Operate when

you attempt to execute a command which reconfigures the controller.

Passwords are not required to view the current state.

Default Passwords & User IDs

User Type

User ID

Default

Password

Operator

Operator1

Operator2

Operator3

Operator4

Configure

Configure5

Configure6

Configure7

Administrator

admin AAAA

Keypad-LCD access cannot change User Type or ID.

NOTE: If you are going to use keypad passwords, your first action after turning passwords ON should be to

change the admin and all other passwords since leaving any password at it’s default value, bypasses

password protection.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Sin comentarios

Black & Decker DCM200C Guía de instalación Pagina 22