Black & Decker FIRESTORM FS210LS Manual de instrucciones descargar pdf (Pagina 15)

EXTENSION WINGS

1. Assemble left extension wing (Fig.23), to the saw table using 1/4-20X1 in.hex head screws (3), 1/4 in.flat washers (6),

1/4 in.lockwashers (3),1/4 in.hex nuts (3).

2. Assemble right extension wing into the threaded holes of the saw using 1/4 in.-20X5/8 in. hex head screws (3),

1/4 in. flat washers (3) 1/4 in. lockwashers (3).

3. With a straight edge, make certain the top, front and rear edges of the extension wings are level with the saw table

before tightening three screws which secure extension wing to table.

Fig. 23

GUIDE RAIL TO SAW

1. Holding the guide rail with the larger holes facing you,

loosely fasten guide rails (A) Fig. 24, to the four

threaded holes (B) in saw table (C) using two 1/4-20

x 1-1/4 in. long screws (D), 1/4 in. lockwashers (E), and

spacers (F).

IMPORTANT: Spacers (F) Fig. 24, are positioned

between guide rails (A) and saw table (C).

2. Fasten guide rails (A) Fig. 24, to extension wings

(G) through hole (K) using the 1/4-20 x 1-1/4 in. long

screw (D), 1/4 in. lockwasher (E), spacer (F), 1/4 in. flat

washer (H), 1/4 in. lockwasher (E), and 1/4-20 hex nut

(J). Then tighten all guide rail mounting hardware.

IMPORTANT: Spacer (F) Fig. 24, is positioned

between guide rails (A) and extension wings (G).

3. Fig. 25, illustrates the guide rails properly assembled

to saw table and extension wings.

Fig. 24

Fig. 25

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

Sin comentarios

Black & Decker FIRESTORM FS210LS Manual de instrucciones Pagina 15