Black & Decker AM8 Manual de usuario descargar pdf (Pagina 32)

Project Center
 
 
E-Mail     Password      Go
Password
Reminder 
 
Home Product 
Guide How-To 
Center Customer 
Service Store Locator
 
Installing Electrical Fixtures
Index>Remodeling Bathrooms>Completing a Bathroom 
Remodeling Project>
Running cables for new electrical fixtures is easiest if wall 
surfaces have been removed. Make the final wiring hookups at 
the fixtures after wall surfaces are finished. 
Follow Local Code requirements for wiring bathrooms. Reduce 
shock hazard by protecting the entire bathroom circuit with 
GFCI receptacles. Install only electrical fixtures that are U.L.-
approved. 
If it is not practical to remove wall surfaces, "retrofit" 
techniques can be used to install vent fans and other fixtures. 
Most wiring connections for bathroom fixtures are easy to 
make, but wiring configurations in electrical boxes vary widely, 
depending on the type of fixture and the circuit layout. 
If you are not confident in your skills, have an electrician install 
and connect fixtures. Unless you are very experienced, leave 
the job of making circuit connections at the main service panel 
to an electrician.
 
Everything You Need:
Tools: 
neon circuit tester
wire stripper
cable ripper
screwdriver
level
Materials: 
NM cable
wire staples
wire nuts
screws
Safety Issues:
Always shut off electrical 
power at the main service 
panel, and test for power 
before working with wires.
 
http://www.blackanddecker.com/projectcenter/documentview.aspx?DOC_ID=p_2_53_16405_16443.html (1 of 3)26.09.2004 23:45:18