Black & Decker MULTI-GAS DETECTORS Manual de usuario Pagina 42

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 71
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 41
BW Defender2
Calibration and Setting Alarm Setpoints
31
Setting the Remaining Alarm Setpoints
The display shows the Low Alarm setpoint for the next sensor.
The Set up/down arrows lights, prompting you to input a new
Low Alarm setpoint.
6. Repeat steps 3 through 6 to set alarm setpoints for CO,
LEL and O
2
.
After all alarm setpoints are set, the audible alarm beeps four
times and the detector returns to normal operation.
Verification (optional)
Test the detector using a gas cylinder other than the one used
in the calibration steps. The gas concentration should not
exceed the sensor's detection range. Confirm that the display
shows the expected concentration.
Vista de pagina 41
1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 70 71

Comentarios a estos manuales

Sin comentarios